Loading tool help

Pete Ebbink · 01-12-2006, 06:03 PM

Hi Clint,

1. The screwdriver end of the tool can be used for the grip screws and also to release the firing pin assembly from the breech block.

I think this function is crude and use my more precise machinist's screw drivers for these tasks...

2. The flat side of the TD tool can be hooked over the magazine follower button and then you place you thumb on the short portion of the "L" that sticks out so you can more easily push down the followe to load bullets into the magazine. This helps with the last 3-4 rounds when the spring tension is hard on a thumb used without the TD tool...

01-12-2006, 06:03 PM	#2
Pete Ebbink User Join Date: Jun 2002 Location: The USA Posts: 5,919 Thanks: 0 Thanked 6 Times in 4 Posts	Hi Clint, 1. The screwdriver end of the tool can be used for the grip screws and also to release the firing pin assembly from the breech block. I think this function is crude and use my more precise machinist's screw drivers for these tasks... 2. The flat side of the TD tool can be hooked over the magazine follower button and then you place you thumb on the short portion of the "L" that sticks out so you can more easily push down the followe to load bullets into the magazine. This helps with the last 3-4 rounds when the spring tension is hard on a thumb used without the TD tool...