Need help...30 Luger Reload recipes

Ron Smith · 04-10-2004, 08:41 PM

Sieger, I've never had any kind of problem. I've had two 30 s and they worked fine in both. They also work well in my Sig 220. Remember.., I am just telling you what my favorite load is. You do as you wish. (Disclaimer)

Ken, The same load should work with "hard" cast bullets. I would'nt use them if they'er kind of soft. I check hardness by pressing the edge of my thumb nail on the base, and run it across hard. If it leaves a groove. They'er too soft. Again, I am not recommending that you use this information. I am merely telling you what I do.
( Cover my A--, boiler plate.)

Ron

04-10-2004, 08:41 PM	#7
Ron Smith User Join Date: Feb 2004 Location: Orygun Posts: 4,243 Thanks: 118 Thanked 245 Times in 150 Posts	Sieger, I've never had any kind of problem. I've had two 30 s and they worked fine in both. They also work well in my Sig 220. Remember.., I am just telling you what my favorite load is. You do as you wish. (Disclaimer) Ken, The same load should work with "hard" cast bullets. I would'nt use them if they'er kind of soft. I check hardness by pressing the edge of my thumb nail on the base, and run it across hard. If it leaves a groove. They'er too soft. Again, I am not recommending that you use this information. I am merely telling you what I do. ( Cover my A--, boiler plate.) Ron __________________ I Still Need DWM side plate #49... if anyone runs across a nice one. What ~Rudyard Kipling~ said...