GT's magazine tool

JR. · 10-06-2003, 10:26 AM

Thats great Ken! I have considered a fixture for removing the follower button, on a really nice mag, it is always a bit tricky! I have used a small piece of steel with a slot in it,that goes inside the follower for support, but sometimes the large dia. of the pin is tight and deforms the follower & the shell on the far side anyway! I have, on occasion cut the follower button off to save the shell, and replaced it with another after the repair..... Thanks again to all for the great feedback! Thanks Ken! till...later....GT

10-06-2003, 10:26 AM	#6
JR. User Join Date: Jun 2002 Location: Flagstaff, AZ Posts: 31 Thanks: 0 Thanked 0 Times in 0 Posts	Thats great Ken! I have considered a fixture for removing the follower button, on a really nice mag, it is always a bit tricky! I have used a small piece of steel with a slot in it,that goes inside the follower for support, but sometimes the large dia. of the pin is tight and deforms the follower & the shell on the far side anyway! I have, on occasion cut the follower button off to save the shell, and replaced it with another after the repair..... Thanks again to all for the great feedback! Thanks Ken! till...later....GT