Newbie, Thrown Into The Luger World By Accident

day late · 03-30-2023, 05:56 PM

With regard to the last two responses.

rhuff, you mention a "felt bob". The rouge I'm very familiar with, but I'm wondering if we are calling the same thing by two different names. I'm thinking of a cone shaped piece of felt. They come in varying sizes to be used for polishing different things in the dental world. Is that by chance what you refer to? If so, they and the rouge are already in the garage.

DonVoigt, the ammo is listed by the manufacturer as target loads. While I do reload, I don't reload for 9mm of any kind. So, all rounds are as the manufacturer made them. Since at worst I expect this would be used as a last-ditch defense weapon, higher powered rounds are not needed. As to the condition of the weapon, in post #3 on this thread, there are pictures of the way it looked when it was given to me. The exterior is quite rough and without doing expensive tests to find out how far the rust has gone, or the money to buy a replacement barrel, I don't see the point in chancing a barrel blowing up on me. The interior did require a bit of work to get it functional, but it now is and wasn't too bad to begin with. The springs were purchased from reputable suppliers. AND BEING A NEWBIE to all of this some springs had multiple copies bought in kits that I didn't realize I had already ordered separately. It is interesting that you bring up the main spring. I had to lose a couple of coils on that one to get it to work right. Cycling spent rounds isn't the problem. It's getting them all to clear the chamber while cycling that is the rub. Most do, but after shooting for 50+ years, I know when I piece isn't quite up to snuff. Something is off in the extraction of spent rounds and I'm not going to rest until I find and fix it.

03-30-2023, 05:56 PM	#36
day late User Join Date: Aug 2022 Posts: 28 Thanks: 0 Thanked 16 Times in 8 Posts	With regard to the last two responses. rhuff, you mention a "felt bob". The rouge I'm very familiar with, but I'm wondering if we are calling the same thing by two different names. I'm thinking of a cone shaped piece of felt. They come in varying sizes to be used for polishing different things in the dental world. Is that by chance what you refer to? If so, they and the rouge are already in the garage. DonVoigt, the ammo is listed by the manufacturer as target loads. While I do reload, I don't reload for 9mm of any kind. So, all rounds are as the manufacturer made them. Since at worst I expect this would be used as a last-ditch defense weapon, higher powered rounds are not needed. As to the condition of the weapon, in post #3 on this thread, there are pictures of the way it looked when it was given to me. The exterior is quite rough and without doing expensive tests to find out how far the rust has gone, or the money to buy a replacement barrel, I don't see the point in chancing a barrel blowing up on me. The interior did require a bit of work to get it functional, but it now is and wasn't too bad to begin with. The springs were purchased from reputable suppliers. AND BEING A NEWBIE to all of this some springs had multiple copies bought in kits that I didn't realize I had already ordered separately. It is interesting that you bring up the main spring. I had to lose a couple of coils on that one to get it to work right. Cycling spent rounds isn't the problem. It's getting them all to clear the chamber while cycling that is the rub. Most do, but after shooting for 50+ years, I know when I piece isn't quite up to snuff. Something is off in the extraction of spent rounds and I'm not going to rest until I find and fix it.