9MMX19 reloading

DavidJayUden · 01-01-2019, 11:27 PM

Me thinks that you are all side-tracked on all this belling conversation. As I mentioned, some new 9's are not designed for cast bullets, plated or otherwise. Also some are very sensitive to the length of the shoulder of the bullet: My PPQ will not take a rounded Parabellum bullet, thus my use of the 9 Cone design. So if the round won't chamber completely, whether the chamber is leaded or if the bullet is contacting the lands, a rim separation is more likely
Yes, the finished product should pass the "plunk" test, but don't ruminate over the minutia.
dju

01-01-2019, 11:27 PM	#15
DavidJayUden Patron LugerForum Patron Join Date: Nov 2008 Posts: 4,047 Thanks: 578 Thanked 1,414 Times in 887 Posts	Me thinks that you are all side-tracked on all this belling conversation. As I mentioned, some new 9's are not designed for cast bullets, plated or otherwise. Also some are very sensitive to the length of the shoulder of the bullet: My PPQ will not take a rounded Parabellum bullet, thus my use of the 9 Cone design. So if the round won't chamber completely, whether the chamber is leaded or if the bullet is contacting the lands, a rim separation is more likely Yes, the finished product should pass the "plunk" test, but don't ruminate over the minutia. dju