.22 cal Luger?

Diver6106 · 03-18-2015, 08:30 PM

I have a 22LR conversion just like this. You can just see the barrel insert sticking out the front. The bolt has been modified for 22LR and the firing pin has the front cone removed so it is flat and a pin added to the left side of it. Then the bolt has been machined for 22LR and drilled on the left side for the firing pin, BUT mine was not machined to feed off a 22LR magazine, so it is single shot (I suspect this is the same?). I plan on getting the bolt machine like the Erma 22LR kit, by machining the bottom and sides. Then it will feed off an Erma kit mag (NOT the slender mag from the standard Erma 22LR Luger). ALSO critical for this to go from single shot to feed off a mag, is BALANCING the springs to the toggle and firing pin for 22LR, and remove the ejector and use the right rear ear on the 22LR mag for ejection.

03-18-2015, 08:30 PM	#6
Diver6106 User Join Date: Sep 2014 Location: Mt. Vernon VA Posts: 245 Thanks: 1,430 Thanked 117 Times in 75 Posts	I have a 22LR conversion just like this. You can just see the barrel insert sticking out the front. The bolt has been modified for 22LR and the firing pin has the front cone removed so it is flat and a pin added to the left side of it. Then the bolt has been machined for 22LR and drilled on the left side for the firing pin, BUT mine was not machined to feed off a 22LR magazine, so it is single shot (I suspect this is the same?). I plan on getting the bolt machine like the Erma 22LR kit, by machining the bottom and sides. Then it will feed off an Erma kit mag (NOT the slender mag from the standard Erma 22LR Luger). ALSO critical for this to go from single shot to feed off a mag, is BALANCING the springs to the toggle and firing pin for 22LR, and remove the ejector and use the right rear ear on the 22LR mag for ejection.