upload photo | donate | calendar
|
my profile |
register |
faq |
search upload photo | donate | calendar |
09-23-2014, 10:03 PM
|
#8 |
|
Moderator
2010 LugerForum Patron 
Join Date: Jun 2002
Location: Santa Teresa New Mexico just outside of the West Texas town of El Paso
Posts: 7,051
Thanks: 1,121
Thanked 5,287 Times in 1,728 Posts
|
Generally the stock iron is modified to fit the lug, not the other way around. The guns were finished products to which a stock was fitted. The slot in the stock iron sometimes needs to be relieved (deepened) a little bit to allow it to be fully connected to the lug. A Dremel tool can be used but a better tool is a riffler file.
__________________
If it's made after 1918...it's a reproduction |
|
|
| The following member says Thank You to Ron Wood for your post: |
|
|
Threaded Mode