Mec-Gar Mag Compatibility Problem

leahmatt · 07-06-2014, 02:13 AM

Thanks for both your replies.

Mag catch seems okay.

I marked where the top of Mec-Gar mag reached in the upper part of the mag well, and that line was .04-.05 inches above where the Mauser mag was.

So, I took a diamond-pointed Dremel engraving tool under a lower power microscope and adjusted the mag catch hole so that the reach of the Mauser mag and the Mec-Gar are now the same.

I'll take it to the range tomorrow and see if this helps.

Thanks

07-06-2014, 02:13 AM	#4
leahmatt User Join Date: Sep 2013 Posts: 6 Thanks: 6 Thanked 0 Times in 0 Posts	Thanks for both your replies. Mag catch seems okay. I marked where the top of Mec-Gar mag reached in the upper part of the mag well, and that line was .04-.05 inches above where the Mauser mag was. So, I took a diamond-pointed Dremel engraving tool under a lower power microscope and adjusted the mag catch hole so that the reach of the Mauser mag and the Mec-Gar are now the same. I'll take it to the range tomorrow and see if this helps. Thanks