Target sight preference???

lfid · 05-30-2008, 01:56 AM

John,

thanks for the info on the soldered sight

it would be interesting if you have time to post a side view of the rear toggle / sight mating surfaces to see how much was milled off the toggle and whether the sight base is also machined flat or is dovetailed in any way into the toggle

has the sight blade or adjust screws loosened up at any point ?

does the sight body look original or narrowed to fit the width of the toggle ?

thanks
Bill

05-30-2008, 01:56 AM	#15
lfid Lifer Lifetime Forum Patron Join Date: Sep 2006 Location: Wichita, KS USA Posts: 453 Thanks: 573 Thanked 96 Times in 53 Posts	John, thanks for the info on the soldered sight it would be interesting if you have time to post a side view of the rear toggle / sight mating surfaces to see how much was milled off the toggle and whether the sight base is also machined flat or is dovetailed in any way into the toggle has the sight blade or adjust screws loosened up at any point ? does the sight body look original or narrowed to fit the width of the toggle ? thanks Bill