LugerForum Discussion Forums my profile | register | faq | search
upload photo | donate | calendar

Go Back   LugerForum Discussion Forums > General Discussion Forums > Repairs, Restoration & Refinishing

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Unread 08-04-2012, 09:27 PM   #1
1964bigfoot
User
 
Join Date: Jul 2012
Posts: 14
Thanks: 0
Thanked 0 Times in 0 Posts
Default Luger will not fire until the trigger is pulled twice.

First time posting.

I picked up a mismatched Luger, looks like a complete upper on a complete lower from the serial numbers that I can see.

I took it to the range today for the first time and here is what it is doing.

1) Load mag in, cycle action as normal.

2) First trigger pull of first round fired as normal.

3) Action cycles and loads second round as normal.

4) Pull trigger and nothing happens, no click no sounds at all.

5) Pull trigger again and it fires as normal.

6) Loads new round and the process repeats. First pull of trigger and nothing second pull of trigger and fire.

I went thru 4 magazines full of ammo to make sure it would repeat and it did without a miss. Always two pulls of the trigger to fire after the initial round is shot. No failures to feed or eject.

I have read a few other posts about a similar problem but they refer to a light hammer strike and not repeatable two pulls of the trigger like this one does.

Anyone have ideas?
1964bigfoot is offline   Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 04:28 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2025, Lugerforum.com