Newbie, Thrown Into The Luger World By Accident

Deputywood · 09-27-2022, 06:18 AM

I had the same problem with a floppy safety. I found the answer in the FAQ section. The safety is purposely bent so that the tip is the only area of the safety arm to touch the frame. The tension for this is determined by the diameter of the pin that holds it place. After the pin was removed, I replaced it with one of slightly larger diameter. My first choice solved the issue and the safety snaps back and forth into the detents on the frame. I used the shank of a numbered drill bit to make the pin. Good luck.

09-27-2022, 06:18 AM	#23
Deputywood User Join Date: Apr 2022 Posts: 71 Thanks: 70 Thanked 85 Times in 35 Posts	I had the same problem with a floppy safety. I found the answer in the FAQ section. The safety is purposely bent so that the tip is the only area of the safety arm to touch the frame. The tension for this is determined by the diameter of the pin that holds it place. After the pin was removed, I replaced it with one of slightly larger diameter. My first choice solved the issue and the safety snaps back and forth into the detents on the frame. I used the shank of a numbered drill bit to make the pin. Good luck.