Loose Grips Sink Ships

Hugh · 07-14-2001, 03:20 PM

Philip,

The problem that you are experiencing is a common one when the inside "ridge" of the grips is too thick and sticks into the magazine well. Try removing one side at a time to determine which side is the culprit. You can then sand down the inside of the grip until the magazine will slide freely. Often it is the groove in the grip where the mag button goes that is not deep enough.

07-14-2001, 03:20 PM	#13
Hugh RIP Join Date: Jun 2002 Location: Southeast Texas Swamp Posts: 2,460 Thanks: 2 Thanked 166 Times in 65 Posts	Re: Caution re: O-rings Philip, The problem that you are experiencing is a common one when the inside "ridge" of the grips is too thick and sticks into the magazine well. Try removing one side at a time to determine which side is the culprit. You can then sand down the inside of the grip until the magazine will slide freely. Often it is the groove in the grip where the mag button goes that is not deep enough.