Hoyt Weathers's 20DWM

Hoyt Weathers · 08-21-2005, 07:26 PM

To all:

I am now at the point of trying to get the recoil spring assembly installed. I have two questions:

1. The hook on the upper end of the recoil spring guide bar should *face* which way - toward the muzzle OR toward the rear?

2. How do you guys get the recoil spring assembly *compressed* enough to get her back into the proper position?

At present I am using a small needle-nose pliers and a drill bit small enough in diameter to go through the hole in bottom end of the guide bar.

I have read that this is a [bad wordbad word of a job to get back into proper position. I can now confirm that.

All suggestions on a feasible solution to my present problem will be appreciated.

Regards,
Hoyt Weathers

08-21-2005, 07:26 PM	#1
Hoyt Weathers User Join Date: Apr 2005 Location: Trinity, Alabama Posts: 61 Thanks: 0 Thanked 0 Times in 0 Posts	Almost there To all: I am now at the point of trying to get the recoil spring assembly installed. I have two questions: 1. The hook on the upper end of the recoil spring guide bar should face which way - toward the muzzle OR toward the rear? 2. How do you guys get the recoil spring assembly compressed enough to get her back into the proper position? At present I am using a small needle-nose pliers and a drill bit small enough in diameter to go through the hole in bottom end of the guide bar. I have read that this is a [bad wordbad word of a job to get back into proper position. I can now confirm that. All suggestions on a feasible solution to my present problem will be appreciated. Regards, Hoyt Weathers __________________ "When I die, if there are no dogs in Heaven then I want to go where they are." (Will Rogers)