BÃ?Â¶hler Steel Barrels. - Page 2

Edward Tinker · 07-22-2005, 12:43 PM

Quote:

Originally posted by Dwight Gruber
Lyn,

One might hazard a WAG that frames were not necessarily assembled into guns in the order that they were manufacturerd, but rather went into a parts "bin" and were retrieved for assembly randomly.

One might hazard a much more speculative WAG, that there was more than one fabrication line for frames and it took time to get each of them converted to stock lugs.

--Dwight

I was thinking there was a standard of applying serial numbers, i.e. that the serial number was not applied until AFTER the gun was complete, it was test fired, proofed and taken apart and all small parts numbered.

ed

Dwight Gruber · 07-22-2005, 05:35 PM

Ed,

You are close, the marking indtructio(GÃ?Â¶rtz & Bryans) have the serial numbers being stamped as the last step -before- power proofing.

--Dwight

Lyn Islaub · 07-22-2005, 06:37 PM

Dwight,
Is that the case for both the frame and barrel? I knew that the barrels were stamped as one of the last parts of the process, hence the halo effect because they were stamped post-bluing. I can't locate a reference to back up my thoughts, but was under the impression that frames got numbered much earlier in the process. Appreciate your input on this, because it's a great learning process.
Lyn

Dwight Gruber · 07-22-2005, 10:40 PM

Lyn,

Thats a good question. Its so good, in fact, that I have started a new discussion with it, you can go directly to it at this link: http://forum.lugerforum.com/showthre...0304#post90304

--Dwight

07-22-2005, 05:35 PM	#22
Dwight Gruber User Join Date: Jun 2002 Location: Portland, Oregon Posts: 3,908 Thanks: 0 Thanked 1,330 Times in 435 Posts	Ed, You are close, the marking indtructio(GÃ?Â¶rtz & Bryans) have the serial numbers being stamped as the last step -before- power proofing. --Dwight

07-22-2005, 06:37 PM	#23
Lyn Islaub Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Phoenix, AZ Posts: 435 Thanks: 3 Thanked 152 Times in 72 Posts	Dwight, Is that the case for both the frame and barrel? I knew that the barrels were stamped as one of the last parts of the process, hence the halo effect because they were stamped post-bluing. I can't locate a reference to back up my thoughts, but was under the impression that frames got numbered much earlier in the process. Appreciate your input on this, because it's a great learning process. Lyn

07-22-2005, 10:40 PM	#24
Dwight Gruber User Join Date: Jun 2002 Location: Portland, Oregon Posts: 3,908 Thanks: 0 Thanked 1,330 Times in 435 Posts	Lyn, Thats a good question. Its so good, in fact, that I have started a new discussion with it, you can go directly to it at this link: http://forum.lugerforum.com/showthre...0304#post90304 --Dwight