Need advice on Non-working Luger

lugerholsterrepair · 02-15-2003, 12:38 PM

To **** the fireing pin on a Luger takes very little pull back, about one half to three quarters of an inch from the breech face. If it was pulled back far enough to discover the hold open then that certainly should **** the weapon.I have discovered, in my later years, that this is a common problem. Lugerdoc and Thor seem to believe it is the connecting lever in the sideplate not travelling far enough back into it's recess to enable the sear bar to re-ingage with the step on the fireing pin. Jerry Burney

02-15-2003, 12:38 PM	#3
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,995 Thanked 3,133 Times in 1,439 Posts	To ** the fireing pin on a Luger takes very little pull back, about one half to three quarters of an inch from the breech face. If it was pulled back far enough to discover the hold open then that certainly should ** the weapon.I have discovered, in my later years, that this is a common problem. Lugerdoc and Thor seem to believe it is the connecting lever in the sideplate not travelling far enough back into it's recess to enable the sear bar to re-ingage with the step on the fireing pin. Jerry Burney __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know."