Luger Carbine

Don H. · 05-11-2003, 12:00 AM

Hub what did you think of the stock? As you can see from the prints there is also a diagram of the butt plate. My father took a piece of black ebony and glued it to the stock then worked it down. After that he cut the lines in it according to the prints then drilled two holes and put two counter sunk screws in it. You wouldn't know by looking that it wasn't a real butt plate. The picture doesn't show it to good. Thought this might help if you're going to make one. Don

05-11-2003, 12:00 AM	#11
Don H. User Join Date: Jun 2002 Location: Albuquerque,NM. Posts: 96 Thanks: 1 Thanked 7 Times in 2 Posts	Hub what did you think of the stock? As you can see from the prints there is also a diagram of the butt plate. My father took a piece of black ebony and glued it to the stock then worked it down. After that he cut the lines in it according to the prints then drilled two holes and put two counter sunk screws in it. You wouldn't know by looking that it wasn't a real butt plate. The picture doesn't show it to good. Thought this might help if you're going to make one. Don