Heavy trigger on 1914 DWM Police 9mm

Doubs · 07-16-2022, 02:56 PM

Put a piece of masking tape on the top of the lower L-arm where it slips under the trigger. That will increase the thickness of the L-arm and the upper L-arm will be pushed in farther at the top. It may require two thicknesses of masking tape but it should release the firing pin sooner as the trigger is depressed. If that improves your trigger pull then add a little JB Weld to the lower L-arm and file it down until the trigger pull is as you want it.

07-16-2022, 02:56 PM	#4
Doubs User Join Date: Jun 2002 Location: Byron, Georgia Posts: 1,742 Thanks: 826 Thanked 1,788 Times in 590 Posts	Put a piece of masking tape on the top of the lower L-arm where it slips under the trigger. That will increase the thickness of the L-arm and the upper L-arm will be pushed in farther at the top. It may require two thicknesses of masking tape but it should release the firing pin sooner as the trigger is depressed. If that improves your trigger pull then add a little JB Weld to the lower L-arm and file it down until the trigger pull is as you want it.