Collectanea <img BORDER="0" src='http://boards.rennlist.com/luger/pic.gif'>

Patrick · 04-04-2001, 04:23 PM

ThatÃ?Â´s what I took it to be. I put the gauge on the scanner but it came out larger. The size is: length 49.5 mm, width 19.5 mm, thickness 2.8 mm. There are two in Bender and it is also in the GÃ?Â¶rtz list of parts that are stamped. The writing is cut into the metal. The ones in Bender have two holes on either side. The ends of the notches on the side have been stamped so that they are 1.35 mm and 1.1 mm deep. The pin should protrude within these limits. The round notch is still a question mark. Patrick

04-04-2001, 04:23 PM	#4
Patrick User Join Date: Jul 2002 Posts: 241 Thanks: 0 Thanked 1 Time in 1 Post	Re: Could it be a Go/No Go Guage? ThatÃ?Â´s what I took it to be. I put the gauge on the scanner but it came out larger. The size is: length 49.5 mm, width 19.5 mm, thickness 2.8 mm. There are two in Bender and it is also in the GÃ?Â¶rtz list of parts that are stamped. The writing is cut into the metal. The ones in Bender have two holes on either side. The ends of the notches on the side have been stamped so that they are 1.35 mm and 1.1 mm deep. The pin should protrude within these limits. The round notch is still a question mark. Patrick