30 luger snap caps

flydive · 06-28-2018, 06:26 AM

I made my own.

Used old casing, removed the spent primer.
Filled half of the casing with hot glue, then filled the primer space again with hot glue.
When cold trimmed away the excess glue primer side to make it flush.
Added a 3d printed bullet. You could use a normal bullet, but I like the red, plastic one for added safety(no mix up)

when the "primer" is damaged by the pin hitting, takes quite a few, just add more glue and trim

06-28-2018, 06:26 AM	#6
flydive User Join Date: Feb 2015 Location: Switzerland Posts: 63 Thanks: 1 Thanked 45 Times in 23 Posts	I made my own. Used old casing, removed the spent primer. Filled half of the casing with hot glue, then filled the primer space again with hot glue. When cold trimmed away the excess glue primer side to make it flush. Added a 3d printed bullet. You could use a normal bullet, but I like the red, plastic one for added safety(no mix up) when the "primer" is damaged by the pin hitting, takes quite a few, just add more glue and trim