Barrel Feed Ramp Angle?

Kiwi Mark · 09-23-2017, 04:01 AM

I like the bull barrel with flats and the front sight for windage. I'm going to mill the rear sight vee sight with 3mm TC end mill to square it off as I
can't see the vee. I'll make the front sight alot higher & file it down at the range until I get the desired results. Before you start to recommend different sights, in New Zealand, we can't import stuff. So I made it. I really appreciate the comments, many thanks.

09-23-2017, 04:01 AM	#8
Kiwi Mark User Join Date: Jan 2017 Posts: 23 Thanks: 0 Thanked 7 Times in 6 Posts	I like the bull barrel with flats and the front sight for windage. I'm going to mill the rear sight vee sight with 3mm TC end mill to square it off as I can't see the vee. I'll make the front sight alot higher & file it down at the range until I get the desired results. Before you start to recommend different sights, in New Zealand, we can't import stuff. So I made it. I really appreciate the comments, many thanks.