C96 Stock repair ?

[Olle]

Originally Posted by gunbugs

To avoid the bit running around on the domed end of the screw, use a center drill first, as they are made for this type of job, and won't flex at all. Then, once you have a small start in the screw, you can go after it with a standard high speed bit. Just make sure it is NEW, and this is its first cut. Take short cuts, with a drop of oil, and blow out the hole frequently. Go slow, no need to hurry the job.

Or you can use a Dremel and a small diamond burr to make a divot. This gives you a second chance to get it on center, as you can simply grind it the direction needed to get it dead on.