"When opportunity knocks!!!"

DavidJayUden · 03-13-2017, 01:52 PM

I know I've been squawking about this issue for a long time, but i fear that my needs are so far outside of the norm that they would benefit no one else. I just measured the front sight on my Navy, (it is a "tall K98 sight" by the way) and it goes right at .398" tall from the bottom of the dovetail to upper tip. And the gun STILL prints a bit high. Someday I may buy a ridiculously tall sight blank and start working it down.
dju

03-13-2017, 01:52 PM	#2
DavidJayUden Patron LugerForum Patron Join Date: Nov 2008 Posts: 4,047 Thanks: 578 Thanked 1,414 Times in 887 Posts	I know I've been squawking about this issue for a long time, but i fear that my needs are so far outside of the norm that they would benefit no one else. I just measured the front sight on my Navy, (it is a "tall K98 sight" by the way) and it goes right at .398" tall from the bottom of the dovetail to upper tip. And the gun STILL prints a bit high. Someday I may buy a ridiculously tall sight blank and start working it down. dju