1939 Toggle Slide Tolerance

DavidJayUden · 07-29-2016, 04:19 PM

Reinserting a toggle assy. into a stripped upper MAY require very gentle manipulation of the upper to get it started, but usually it is more a matter of finding the correct angle for insertion. I suppose a good caliper could tell a story on whether the amount of "spread" changes between the chamber area and the back end.
But quite honestly it all sounds like a non-problem. Or maybe an excuse to buy another Luger...
dju

07-29-2016, 04:19 PM	#10
DavidJayUden Patron LugerForum Patron Join Date: Nov 2008 Posts: 4,047 Thanks: 578 Thanked 1,414 Times in 887 Posts	Reinserting a toggle assy. into a stripped upper MAY require very gentle manipulation of the upper to get it started, but usually it is more a matter of finding the correct angle for insertion. I suppose a good caliper could tell a story on whether the amount of "spread" changes between the chamber area and the back end. But quite honestly it all sounds like a non-problem. Or maybe an excuse to buy another Luger... dju