![]() |
my profile |
register |
faq |
search upload photo | donate | calendar |
|
![]() |
#1 |
User
Join Date: Apr 2015
Location: near Charlotte NC
Posts: 4,681
Thanks: 1,443
Thanked 4,355 Times in 2,041 Posts
|
![]()
John,
for what it is worth, I believe you have analysed the forces correctly. Take down latch would see no pressure at all in firing, only to stop the forward motion in counter recoil as you observe. |
![]() |
![]() |
![]() |
#2 |
User
Join Date: Apr 2006
Location: Texas
Posts: 302
Thanks: 496
Thanked 356 Times in 138 Posts
|
![]()
IMHO
Where the rear toggle link receiver ear intersects with the horizontal top of the receiver fork is a very sharp corner. Sharp corners can be points of high stress concentration. The centerline of the receiver ear rear toggle pivot axle is slightly above the breech block centerline. This slight centerline difference introduce a bending moment into the receiver ear during recoiling of the breech block toggle assembly. The bending moment would be like tearing a sheet of paper as opposed to pulling it in tension. As a police weapon and over almost a hundred years of use the receiver ear has been subjected to impact forces each time the Luger was fired. During this period apparently a crack was started at receiver ear-fork intersection. Once the crack was started additional shooting would propagate the crack to ultimate failure. That's my two cents. |
![]() |
![]() |
The following 3 members says Thank You to Dick Herman for your post: |
![]() |
|
|