Repaired, created, or cloned- 4" P 08 with '06 navy sight

sheepherder · 07-29-2015, 10:32 PM

It be magic...

John Sabato · 07-30-2015, 09:05 AM

Quote:

Originally Posted by sheepherder

It be magic...

As I recall, I think Rich doesn't even mill the front sight base until after fitting the barrel and chambering installed in the receiver... Am I correct about your 'magic' ?

DonVoigt · 07-30-2015, 09:18 AM

Quote:

Originally Posted by John Sabato

As I recall, I think Rich doesn't even mill the front sight base until after fitting the barrel and chambering installed in the receiver... Am I correct about your 'magic' ?

That's kinda what I figured; not "magic" more like "cheating", but just a little.

sheepherder · 07-30-2015, 10:05 AM

Quote:

Originally Posted by John Sabato

As I recall, I think Rich doesn't even mill the front sight base until after fitting the barrel and chambering installed in the receiver... Am I correct about your 'magic' ?

Quote:

Originally Posted by DonVoigt

That's kinda what I figured; not "magic" more like "cheating", but just a little.

I had originally posted a link or Search to a thread about 'odd Numrich barrels' but when I checked it I remembered it was for a barrel that had NO front sight base, so I fabricated one...

That doesn't help you...You have a barrel with a front sight base. If you chase your thread, you'll be able to screw it into your barrel extension and find out where you are. The thread is 20tpi which is .050" between threads. With a 'crush factor' of ~.004", the most you could be off is ~.046". That is, if you screwed it in all the way until you couldn't tighten it any more [by hand], and the front sight was exactly 12:00 o'clock, then you'd need to take .046" off the flange. But it won't be that much, so you could thin the flange and cut back the OAL and get a proper fit. But you would almost certainly need to deepen the chamber, and re-cut the extractor notch and feed ramp.

Adding a shim to a mis-matched barrel/extension combination opens up similar cans of worms. Will it need tweaking? Cut chamber, notch, ramp? Thin the shim?

There is a thread here somewhere where that was done with a OEM Luger barrel, but I've lost it...

I would chase your barrel thread and see whatcha got...

07-29-2015, 10:32 PM	#1
sheepherder Lifer Lifetime Forum Patron Join Date: Feb 2009 Location: ...on the 'ol Erie Canal... Posts: 8,198 Thanks: 1,416 Thanked 4,462 Times in 2,336 Posts	It be magic... __________________ I like my coffee the way I like my women... ...Cold and bitter... Last edited by sheepherder; 07-30-2015 at 02:00 AM.