Exploded view of Interarms/Mauser 9mm

hayhugh · 02-05-2015, 08:28 AM

Well Bill after looking at the end plate (washer) with a loupe there does seem to be a raged edge in the inter circle. So I can assume it did break off from the rest of the pin.

I have tried a toggle pin from a regular Luger and it does interchange length wise and the lip seems to be a little bit stronger - That might be the way to go. Going with a replacement I/M pin would seem to be asking for the same problem as I now have. You stated others have had this problem so it must be factory fault never corrected.

02-05-2015, 08:28 AM	#9
hayhugh User Join Date: Oct 2013 Location: Florida/Penna Posts: 898 Thanks: 893 Thanked 514 Times in 276 Posts	Well Bill after looking at the end plate (washer) with a loupe there does seem to be a raged edge in the inter circle. So I can assume it did break off from the rest of the pin. I have tried a toggle pin from a regular Luger and it does interchange length wise and the lip seems to be a little bit stronger - That might be the way to go. Going with a replacement I/M pin would seem to be asking for the same problem as I now have. You stated others have had this problem so it must be factory fault never corrected.