Inserting a take down lever spring

CAP Black · 11-18-2013, 10:48 PM

The positioning so far seems to be to place it to the left, standing on the point with the bent end pointing to the right. Sort of forming the letter "F" with the middle cross piece missing. Am I getting close? Will it help to keep it in place (after I get it in there) by putting some grease on it? And that also will allow for easier fitting of the two pieces to each other?? Would appreciate some help with this rascal.
thanks
Jack

11-18-2013, 10:48 PM	#2
CAP Black User Join Date: Dec 2008 Location: Fairmont, WV Right here in Mountaineer country and God's country Posts: 767 Thanks: 100 Thanked 174 Times in 96 Posts	The positioning so far seems to be to place it to the left, standing on the point with the bent end pointing to the right. Sort of forming the letter "F" with the middle cross piece missing. Am I getting close? Will it help to keep it in place (after I get it in there) by putting some grease on it? And that also will allow for easier fitting of the two pieces to each other?? Would appreciate some help with this rascal. thanks Jack