DWM 1908 Commercial

Dwight Gruber · 01-23-2013, 03:50 PM

The frame is definitely a P08 frame. The left rear frame grip is cut slightly higher than a non-grip safety Luger, to make room for the grip safety. When replacing the grip panel with a P08 grip, a gap is left between the frame and the profile of the grip.

You can see in the left illustration thte gap left behind the grip of a 1906 with grip safety removed, versus the P08 in this thread which is relieved lower and the grip fits properly.

I have concerns about the c/N on the barrel, could you post a sharp, tight closeup of it?

--Dwight

01-23-2013, 03:50 PM	#12
Dwight Gruber User Join Date: Jun 2002 Location: Portland, Oregon Posts: 3,908 Thanks: 0 Thanked 1,330 Times in 435 Posts	The frame is definitely a P08 frame. The left rear frame grip is cut slightly higher than a non-grip safety Luger, to make room for the grip safety. When replacing the grip panel with a P08 grip, a gap is left between the frame and the profile of the grip. You can see in the left illustration thte gap left behind the grip of a 1906 with grip safety removed, versus the P08 in this thread which is relieved lower and the grip fits properly. I have concerns about the c/N on the barrel, could you post a sharp, tight closeup of it? --Dwight Attached Images