New DWM 1911 Luger

[rhuff]

Originally Posted by lugerholsterrepair

The spring behind the extractor is under some pressure but not enough to launch parts.

I have to respectfully disagree with this statement. I was installing a "new" extractor with a new extractor spring to a breachblock that I purchased last week. I was having a bit of problem since the new extractor spring is a little longer until it takes it's set, and it is difficult to get the pin in correctly. I have done this procedure many times before without any drama. Anyway, the extractor popped out, and at least I found it, but the new extractor spring is at a place unknown to mankind. I heard where I though it landed, but after extensive searching....I gave up. I would have been much more upset if I had lost the extractor also.