Identification of DWM Luger

Norme · 05-13-2012, 02:47 PM

Hi Dave, Forgive me for asking another obvious question. Have you cleaned this gun? Specifically, have you scrubbed out the bore with a bronze brush and a solvent like Hoppes #9? The chamber on 9mm Lugers is constricted near the end (it appears as a ring when you peer into the chamber), and is intended to form a gas tight seal. Your chamber may be fouled up. Good luck! Norm

05-13-2012, 02:47 PM	#16
Norme Always A Lifetime Forum Patron Join Date: Jul 2009 Location: Colorado Posts: 2,417 Thanks: 226 Thanked 2,607 Times in 933 Posts	Hi Dave, Forgive me for asking another obvious question. Have you cleaned this gun? Specifically, have you scrubbed out the bore with a bronze brush and a solvent like Hoppes #9? The chamber on 9mm Lugers is constricted near the end (it appears as a ring when you peer into the chamber), and is intended to form a gas tight seal. Your chamber may be fouled up. Good luck! Norm