Identification of DWM Luger

DocDave · 05-13-2012, 01:58 PM

Thankk you for the replies. I broke the Luger down and there is nothinh appaernet in the barrel.

When I slide a 9 mm 9 x 19 into the chamber about 1/8 to 1/16 will not go in so that it can fire.

The tolerances seem to just be too tight of our new 9 mm cartridges.

I tried Winchester and also Lellier and Bellot FWJ. Sometimes one or two will fire but then it jams.

I am curious if anyone else has experienced such tolerances.

This appears to be a DWM matched number luger but no date on it with serial number 4051.

Any other suggestions on what ammo manufatcurer I might try

Thanks again

Dave

05-13-2012, 01:58 PM	#13
DocDave User Join Date: Mar 2012 Posts: 10 Thanks: 0 Thanked 0 Times in 0 Posts	9mm cartridge sticking in chamber Thankk you for the replies. I broke the Luger down and there is nothinh appaernet in the barrel. When I slide a 9 mm 9 x 19 into the chamber about 1/8 to 1/16 will not go in so that it can fire. The tolerances seem to just be too tight of our new 9 mm cartridges. I tried Winchester and also Lellier and Bellot FWJ. Sometimes one or two will fire but then it jams. I am curious if anyone else has experienced such tolerances. This appears to be a DWM matched number luger but no date on it with serial number 4051. Any other suggestions on what ammo manufatcurer I might try Thanks again Dave