P08 Trigger Problem

wisgro123 · 03-07-2012, 11:24 AM

Thanks for responding. Before I checked the side plate fit I put a drop of oil at the axle pin where it goes through the lever in the back of the side plate. I then carefully inserted the plate into the notch. (I took it off and replaced it a few times, checking carefully for fit.) If I hold the pistol so that I am facing the muzzle I can see a small gap between the side plate and side of the receiver. I can slide 3 thicknesses of regular bond paper edgewise into the gap (about 1/64). I can press the side plate snugly to the receiver but it doesn't stay there. Pressing the side plate before pulling the trigger doesn't help. I then cocked and pulled the trigger very slowly. Feels like something is not operating smoothly, like an obstruction then fires. Unfortunately when I cocked it again I had to pull the trigger 3 times before it fired.

03-07-2012, 11:24 AM	#1
wisgro123 User Join Date: Aug 2008 Posts: 24 Thanks: 16 Thanked 0 Times in 0 Posts	Thanks for responding. Before I checked the side plate fit I put a drop of oil at the axle pin where it goes through the lever in the back of the side plate. I then carefully inserted the plate into the notch. (I took it off and replaced it a few times, checking carefully for fit.) If I hold the pistol so that I am facing the muzzle I can see a small gap between the side plate and side of the receiver. I can slide 3 thicknesses of regular bond paper edgewise into the gap (about 1/64). I can press the side plate snugly to the receiver but it doesn't stay there. Pressing the side plate before pulling the trigger doesn't help. I then cocked and pulled the trigger very slowly. Feels like something is not operating smoothly, like an obstruction then fires. Unfortunately when I cocked it again I had to pull the trigger 3 times before it fired.