Tight Pin

Lugerdoc · 07-04-2011, 11:35 AM

Jack, Your mid toggle link, may not be numered inside. The "OZ" that you mentioned on the left side is probably actually a crown/N test fire proof. The number on the rear of an Alpha commerical breech block is NOT a serial #, so these 2 digits will not match your serial, althought the last 2 digit on the inside of your extractor should match the serial #. I have seen some forward axels actually break in half inside, making them difficult to remove; Best done with a high pressure press. TH

07-04-2011, 11:35 AM	#13
Lugerdoc Patron LugerForum Patron Join Date: Jun 2002 Location: POB 398 St.Charles,MO. 63302 Posts: 5,089 Thanks: 6 Thanked 737 Times in 484 Posts	Jack, Your mid toggle link, may not be numered inside. The "OZ" that you mentioned on the left side is probably actually a crown/N test fire proof. The number on the rear of an Alpha commerical breech block is NOT a serial #, so these 2 digits will not match your serial, althought the last 2 digit on the inside of your extractor should match the serial #. I have seen some forward axels actually break in half inside, making them difficult to remove; Best done with a high pressure press. TH __________________ Tom Heller POB 398 ST.Charles, MO. 63302 Tel 636-447-3006 lugerdoc@charter.net