Replace P08 barrell

[sheepherder]

Originally Posted by Viper_block_50

Hello!
The barrell on my P08 is quite worn out but I have a replacement barrell.

What is the best way to remove the old barrell without making any scratches or damaging the old one?

Bjorn
Norway

I just now noticed that you're in Norway...(not that there's anything wrong with that)...

I use these -

http://cgi.ebay.com/PO8-LUGER-BARREL...mZ370184828329



http://cgi.ebay.com/BARREL-VISE-W-5-...mZ370166886199




But it would depend on how many you plan on swapping...or if you can resell them when you're done with your one...

Is your "new" barrel an original Luger barrel??? Or an aftermarket barrel from one of the many mfg's??? If original Luger mfg, it should be good to torque up without machining...If it's a Numrich or Sarco barrel, don't be surprised if it screws in and the front sight is on the side or bottom of the pistol...