Need Pic of Broomhandle Lockwork

alvin · 05-04-2009, 08:15 PM

Sorry, I was busy on a little bit private stuff these days which drove me crazy.... so I did not reply earlier.

Probably the sear spring is OK, but the lock frame latch's "U" opening does not match this sear spring. The spring should keep press the latch regardless the position of the hammer.

Those unnumbered latch is very commonly available. You can replace one easily. This is another point that I don't understand Mauser -- "If you could not guarantee inter-exchangability of this part, why did you drop the number on it?"

05-04-2009, 08:15 PM	#10
alvin User Join Date: Jul 2007 Location: US Posts: 3,843 Thanks: 132 Thanked 729 Times in 438 Posts	Sorry, I was busy on a little bit private stuff these days which drove me crazy.... so I did not reply earlier. Probably the sear spring is OK, but the lock frame latch's "U" opening does not match this sear spring. The spring should keep press the latch regardless the position of the hammer. Those unnumbered latch is very commonly available. You can replace one easily. This is another point that I don't understand Mauser -- "If you could not guarantee inter-exchangability of this part, why did you drop the number on it?"