![]() |
my profile |
register |
faq |
search upload photo | donate | calendar |
|
![]() |
#1 | |
Moderator
2010 LugerForum Patron Join Date: Jun 2002
Location: Santa Teresa New Mexico just outside of the West Texas town of El Paso
Posts: 7,040
Thanks: 1,106
Thanked 5,257 Times in 1,724 Posts
|
![]() Quote:
If I understand your question, the answer is yes. To disassemble the receiver from the frame, you must "hold back" the barrel/receiver group so that you can turn the locking bolt down, remove the side plate and slide the receiver forward off of the frame. The easiest way for a beginner to hold back the barrel/reciever is press the muzzle against a solid surface until the receiver moves fully to the rear (about 1/4") and rotate the locking bolt down. This is of course done with an UNLOADED gun and the magazine removed. ![]()
__________________
If it's made after 1918...it's a reproduction |
|
![]() |
![]() |
![]() |
|
|