Mitchell p-08 stainless luger parts

Dentex · 08-15-2008, 10:43 PM

Here is the deal with Aimco. I spoke with Mr. Romo and described the situation to him. He said to send him the part and he would most likely replace it. The caveat is that there were three different "generations" of these pistols and all the parts are dimensionally different so swapping out parts is a crapshoot. Mine was an early 3rd gen. model, marketed by Aimco. Late 3rd gen. was roll marked Orimar. The 1st gen. models went to Mitchell and the 2nd gen. models went to Stoeger. Aimco today consists of spare parts in very limited quantity for these pistols. The actual guns have and remain out of production for the past several years. Mine has served me well and Mr. Romo has satisfied me on customer service issues. He did mention that the investors did not materialize in order for production to continue so the project became cost prohibitive.

08-15-2008, 10:43 PM	#9
Dentex New User Join Date: Aug 2008 Posts: 2 Thanks: 0 Thanked 0 Times in 0 Posts	Here is the deal with Aimco. I spoke with Mr. Romo and described the situation to him. He said to send him the part and he would most likely replace it. The caveat is that there were three different "generations" of these pistols and all the parts are dimensionally different so swapping out parts is a crapshoot. Mine was an early 3rd gen. model, marketed by Aimco. Late 3rd gen. was roll marked Orimar. The 1st gen. models went to Mitchell and the 2nd gen. models went to Stoeger. Aimco today consists of spare parts in very limited quantity for these pistols. The actual guns have and remain out of production for the past several years. Mine has served me well and Mr. Romo has satisfied me on customer service issues. He did mention that the investors did not materialize in order for production to continue so the project became cost prohibitive.