Update on project....

davjed · 07-10-2008, 04:38 PM

Well it ain't purty but it's almost a Luger (or should I say several Lugers) again. Except for the front sight, a safety lever, a coupling pin and a magazine release spring, all I need is to install and headspace the barrel. I was going to send it to someone this week to do that for me but another board member requested a swap of the rear toggle so I am going to accommodate him. I got a Wolf service pack for the coil springs and the grips from Numrich. The grips will need to be fitted better.....they were made in India. When all is finished I will bead blast and reblue it. No collector value to it...just a fun project and shooter.

07-10-2008, 04:38 PM	#18
davjed User Join Date: May 2008 Location: Central Louisiana Posts: 22 Thanks: 1 Thanked 1 Time in 1 Post	Update....... Well it ain't purty but it's almost a Luger (or should I say several Lugers) again. Except for the front sight, a safety lever, a coupling pin and a magazine release spring, all I need is to install and headspace the barrel. I was going to send it to someone this week to do that for me but another board member requested a swap of the rear toggle so I am going to accommodate him. I got a Wolf service pack for the coil springs and the grips from Numrich. The grips will need to be fitted better.....they were made in India. When all is finished I will bead blast and reblue it. No collector value to it...just a fun project and shooter.