![]() |
my profile |
register |
faq |
search upload photo | donate | calendar |
![]() |
#8 |
Moderator
Lifetime Forum Patron Join Date: Jun 2002
Location: Arizona/Colorado
Posts: 7,775
Thanks: 4,995
Thanked 3,133 Times in 1,439 Posts
|
![]()
Marlan, This IS a hardned part. Most springs are. I have switched out many originals. I wouldn't fool around with a repro. If LugerDoc has an original it's my guess it will have a good chance of slipping right in.
These are tricky to install though. Like the takedown spring, they have an arch in their back. This arch must be depressed to slip the rearward round socket into it's round hole in the frame. I usually slip in the ejector protrusion and run my finger rearwards to press out the arch and sometimes you get lucky, it simply pops into place. Other times you have to finagle it, look closely under a magnifying light and see if it needs to go forward or back. I have also used a plastic tap hammer to nudge it a bit. I guess it depends on how handy you are. Did you get it out? Jerry Burney
__________________
Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) ![]() "For those who Fight For It, Life has a flavor the protected will never know." |
![]() |
![]() |
|
|