Markings On Ari Barrels

George Anderson · 06-21-2006, 11:37 AM

Paul, no one here will laugh at your English.

A 1916 dated LP08 should have a barrel that is serial numbered on the bottum where the barrel joins the receiver. It should also include a measurement of the bore such as "8,83". The rear sight should also be serial numbered both on the base (top) and ramp (right side), these markings will only include the last two digits in the serial number.

All 1916 LP08s will also have fine tune sites, both front and rear. These are easily identified as the small set screws with two small holes for a spanner rather than a slot.

06-21-2006, 11:37 AM	#2
George Anderson Lifer Lifetime Forum Patron Join Date: Jul 2002 Location: VA Posts: 3,592 Thanks: 1,773 Thanked 2,531 Times in 788 Posts	Paul, no one here will laugh at your English. A 1916 dated LP08 should have a barrel that is serial numbered on the bottum where the barrel joins the receiver. It should also include a measurement of the bore such as "8,83". The rear sight should also be serial numbered both on the base (top) and ramp (right side), these markings will only include the last two digits in the serial number. All 1916 LP08s will also have fine tune sites, both front and rear. These are easily identified as the small set screws with two small holes for a spanner rather than a slot.