Radom gunsmith out there?

Roadkill · 04-04-2005, 09:59 AM

Thanks Tom, I kept looking at it, finally put it back together in a different sequence, made sure the mainspring went in and was positioned against the sear & hammer, then the squeeze safety to hold the spring in, next the bottom part, somehowthis put the spring tension back on the hammer, got it back together and it worked. Took it shooting yesterday and it functioned fine. Is it possible that the center leaf of the mainspring slipped off the sear/ hammer? I'll try it for a while, if it does it again I'll need a mainspring and sear. Thanks

Rgg

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

04-04-2005, 09:59 AM	#5
Roadkill User Join Date: Jun 2002 Posts: 1,634 Thanks: 1 Thanked 28 Times in 17 Posts	Thanks Tom, I kept looking at it, finally put it back together in a different sequence, made sure the mainspring went in and was positioned against the sear & hammer, then the squeeze safety to hold the spring in, next the bottom part, somehowthis put the spring tension back on the hammer, got it back together and it worked. Took it shooting yesterday and it functioned fine. Is it possible that the center leaf of the mainspring slipped off the sear/ hammer? I'll try it for a while, if it does it again I'll need a mainspring and sear. Thanks Rgg