continued

Steve Richards · 08-21-2003, 08:20 PM

A word of caution on polishing the matte parts of the frame. Quite a while back somebody posted that they had polished the entire gun and regretted it because it was too reflective. I have no personal experience so cannot give any other advice on this.

I have seen pictures of some of the toggle parts mixed with vintage. If your magazine looks like a vintage, it should be interchangable. If the sides are flat, it is not.

I stopped experimenting when I put a stainless top assembly on a 1970's frame and then spent the better part of an hour getting it apart!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

08-21-2003, 08:20 PM	#4
Steve Richards User Join Date: Jun 2002 Location: Beaverton, Oregon Posts: 487 Thanks: 0 Thanked 1 Time in 1 Post	A word of caution on polishing the matte parts of the frame. Quite a while back somebody posted that they had polished the entire gun and regretted it because it was too reflective. I have no personal experience so cannot give any other advice on this. I have seen pictures of some of the toggle parts mixed with vintage. If your magazine looks like a vintage, it should be interchangable. If the sides are flat, it is not. I stopped experimenting when I put a stainless top assembly on a 1970's frame and then spent the better part of an hour getting it apart!