GT's magazine tool

JR. · 10-06-2003, 10:26 AM

Thats great Ken! I have considered a fixture for removing the follower button, on a really nice mag, it is always a bit tricky! I have used a small piece of steel with a slot in it,that goes inside the follower for support, but sometimes the large dia. of the pin is tight and deforms the follower & the shell on the far side anyway! I have, on occasion cut the follower button off to save the shell, and replaced it with another after the repair..... Thanks again to all for the great feedback! Thanks Ken! till...later....GT

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

10-06-2003, 10:26 AM	#6
JR. User Join Date: Jun 2002 Location: Flagstaff, AZ Posts: 31 Thanks: 0 Thanked 0 Times in 0 Posts	Thats great Ken! I have considered a fixture for removing the follower button, on a really nice mag, it is always a bit tricky! I have used a small piece of steel with a slot in it,that goes inside the follower for support, but sometimes the large dia. of the pin is tight and deforms the follower & the shell on the far side anyway! I have, on occasion cut the follower button off to save the shell, and replaced it with another after the repair..... Thanks again to all for the great feedback! Thanks Ken! till...later....GT