Trigger job?

Kiwi · 04-01-2020, 11:19 AM

Out of curiosity I examined the firing pins of my 2 last night.
Under an 8x Loupe both had crud on the surface engaged by the sear.
Crud being microscopic bits of either metal or powder stuck to the surface with oil.
Actually looked more like fine metal filings (not me) than powder

A toothbrush and cleaning patch.
Unfortunately I am in a lockdown State and cannot field test the result at this time

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

04-01-2020, 11:19 AM	#17
Kiwi User Join Date: Mar 2019 Location: Wrong side of the Delaware river Posts: 339 Thanks: 240 Thanked 488 Times in 192 Posts	Out of curiosity I examined the firing pins of my 2 last night. Under an 8x Loupe both had crud on the surface engaged by the sear. Crud being microscopic bits of either metal or powder stuck to the surface with oil. Actually looked more like fine metal filings (not me) than powder A toothbrush and cleaning patch. Unfortunately I am in a lockdown State and cannot field test the result at this time