Hey, GT! Your Numrich snail drums

G.T. · 10-22-2018, 06:10 PM

Hi Mike, hey! Correct procedure is... Put on safety glasses!! Remove all loose rounds that you can.... then reset the winding lever in the locked / tensioned position.. then remove cover screw, and also angle area small cross bolt, cover assembly with towel, and remove cover...
Clear jam, polish are of jam, re-install follower and spring, and reassemble... reload and retry... repeat as necessary... GT....

... easy way, send it to me and I'll correct!....

10-22-2018, 06:10 PM	#1
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,527 Thanks: 1,323 Thanked 3,710 Times in 1,014 Posts	drum disassembly Hi Mike, hey! Correct procedure is... Put on safety glasses!! Remove all loose rounds that you can.... then reset the winding lever in the locked / tensioned position.. then remove cover screw, and also angle area small cross bolt, cover assembly with towel, and remove cover... Clear jam, polish are of jam, re-install follower and spring, and reassemble... reload and retry... repeat as necessary... GT....... easy way, send it to me and I'll correct!....

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode