last little thing?.....Mec-Gar mag bottoms

Puretexan · 06-02-2017, 04:44 PM

I know this is an old post, but I'm amazed that everybody can perform the
quality they do without the right tools. You can buy a small very precision
mill from Grizzley for $754 shipped. I bought my small harbor freight lathe
for $500 used. Its called a precision where they hand scrape the rails. Both
will do quality work, equal to your talents.

DSCF0001.jpg

DSCF0002.jpg

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

06-02-2017, 04:44 PM	#26
Puretexan User Join Date: May 2017 Location: Pearland Texas Posts: 176 Thanks: 11 Thanked 70 Times in 36 Posts	I know this is an old post, but I'm amazed that everybody can perform the quality they do without the right tools. You can buy a small very precision mill from Grizzley for $754 shipped. I bought my small harbor freight lathe for $500 used. Its called a precision where they hand scrape the rails. Both will do quality work, equal to your talents. DSCF0001.jpg DSCF0002.jpg