Swapping Complet toggle assembly

DavidJayUden · 04-03-2017, 09:06 AM

If you are uncomfortable but too cheap/lazy to consult a gunsmith, as am I, load only one round the first time out and then examine the fired brass for signs of bulging , splitting, etc.
Or contact one of our forum members like LugerDoc or G.T, and see what they have to say.
Or get a set of GO and NO-GO gauges and see for yourself.
Good luck and happy shooting.
dju

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

04-03-2017, 09:06 AM	#1
DavidJayUden Patron LugerForum Patron Join Date: Nov 2008 Posts: 4,047 Thanks: 578 Thanked 1,414 Times in 887 Posts	If you are uncomfortable but too cheap/lazy to consult a gunsmith, as am I, load only one round the first time out and then examine the fired brass for signs of bulging , splitting, etc. Or contact one of our forum members like LugerDoc or G.T, and see what they have to say. Or get a set of GO and NO-GO gauges and see for yourself. Good luck and happy shooting. dju