fails to **** firing pin

thater · 01-22-2003, 04:17 PM

I checked it out and I think that everything is OK. The spring under the botton is new. The clip spring is new. I tried a new mainspring, but it seemed too stiff. The action would often close without grabbing another round. The mainspring I have now is chopped. I will try heavier ammo with both springs and see what I get. Remember, the problem is not that I cannot sear bar to release the firing pin, but that the thing is not cocked after firing a round. I pull har on the action, it clicks, I slap it back down and bang.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

01-22-2003, 04:17 PM	#4
thater User Join Date: Oct 2002 Posts: 13 Thanks: 0 Thanked 0 Times in 0 Posts	I checked it out and I think that everything is OK. The spring under the botton is new. The clip spring is new. I tried a new mainspring, but it seemed too stiff. The action would often close without grabbing another round. The mainspring I have now is chopped. I will try heavier ammo with both springs and see what I get. Remember, the problem is not that I cannot sear bar to release the firing pin, but that the thing is not cocked after firing a round. I pull har on the action, it clicks, I slap it back down and bang.