upload photo | donate | calendar
|
my profile |
register |
faq |
search upload photo | donate | calendar |
|
|
06-01-2016, 06:45 AM
|
#1 |
|
Patron
LugerForum Patron Join Date: Sep 2002
Location: VA
Posts: 96
Thanks: 19
Thanked 57 Times in 20 Posts
|
Jerry
There is no sleeve on this one, which I think is correct for the AEG Loaders. I have three Bing loaders, one long body and two short body which all have the sleeve in place. I added a couple of photos to the previous post. Thanks Ed |
|
|
| The following member says Thank You to regul for your post: |
|
06-01-2016, 09:36 AM
|
#2 |
|
Lifer
Lifetime Forum Patron Join Date: Jun 2002
Location: Chandler Arizona
Posts: 3,541
Thanks: 1,342
Thanked 3,743 Times in 1,020 Posts
|
Awww crap!
Hi to all, as the handle is symmetrical it is an easy mistake to make at the factory to rivet the compression attachment on upside down, and rather then toss it, its an Awwww crap! I'll just put the screw in from the opposite side.. I'll bet there's more just like it, although there should be a majority, or correct assembly procedure that was supposed to be followed.... No other reason, unless a careless repair at some time?..... til..lat'r...GT...
|
|
|
|
| The following 3 members says Thank You to G.T. for your post: |
|
06-01-2016, 12:19 PM
|
#3 |
|
RIP
Join Date: Feb 2009
Posts: 195
Thanks: 0
Thanked 21 Times in 18 Posts
|
Handle put on wrong at factory.
Hi guys, this handle was put on wrong at the factory.The guy just
sent it on it's way.He drilled and taped it from the wrong side.There is no tube in a A.E.G. like the Bing loader Thanks,The fatkat,George |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
