Grip rejuvination

mrerick · 03-03-2016, 11:15 AM

What is "aircraft stripper"?

i was with you up to the epoxy (which is something that was not available when Lugers were made).

I have used hand rubbed dilute boiled linseed oil as a final finish. You take BLO and dilute it one part mineral spirits to two parts BLO, and then apply it with a cotton ball. It has to be rubbed into the surface by hand since the heat of the friction is what helps melt it into the wood's pores. Multiple coats are needed, with a light burnishing with 0000 steel wool in between.

Marc

03-03-2016, 11:15 AM	#6
mrerick Super Moderator - Patron LugerForum Life Patron Join Date: Dec 2009 Location: Eastern North Carolina, USA Posts: 3,925 Thanks: 1,377 Thanked 3,139 Times in 1,520 Posts	What is "aircraft stripper"? i was with you up to the epoxy (which is something that was not available when Lugers were made). I have used hand rubbed dilute boiled linseed oil as a final finish. You take BLO and dilute it one part mineral spirits to two parts BLO, and then apply it with a cotton ball. It has to be rubbed into the surface by hand since the heat of the friction is what helps melt it into the wood's pores. Multiple coats are needed, with a light burnishing with 0000 steel wool in between. Marc __________________ Igitur si vis pacem, para bellum - - Therefore if you want peace, prepare for war.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode